Bondtech Heat-break Kit for Prusa Mini
Included in this kit:
- 1x 32×5.48 mm stainless steel heat-break
- 1x 35.3 mm 2/4 chamfered PTFE tube
Recommendation
We recommend to use thermal paste to properly fit the Bondtech heat-break in the Mini’s heat-sink.
Notes on twisting the heat-break
To address the heat creep issue the design features a narrower section with thinner walls. When removing the heater block or changing nozzles, caution is required.
Before removing the heater block from the heat-break (or vice versa), heat-up the nozzle, hold the heater block and release some tightening pressure from the nozzle. Let the whole group cool down. After, you can simply unscrew the heat-break from the heater block.
To remove or replace a nozzle, never forget to secure the heater block before twisting the nozzle.
Community Sourced Design
This heat-break design was proposed to us by Olof Ogland and we adjusted it to its final form during the deep testing we performed on the Prusa Mini.
Beoordelingen
Er zijn nog geen beoordelingen.